Roborock S5 Robotic Vacuum Cleaner installation guide

Roborock S5 Robotic Vacuum Cleaner seamlessly navigates from room to room in your home, mapping everywhere it goes and cleaning every spot. If it runs low on power, it returns to recharge and continues where it left off. 2000Pa of strong suction power, combined with a thorough mopping system cleans every inch of your floors. In the Mi Home app you can send it to clean any spot, start a clean cycle, or schedule cleaning for when you are not home.

Roborock S5 Robotic Vacuum Cleaner installation guide following the method below.

1. Plug the Roborock S5 Robotic Vacuum Cleaner dock charger into the interface of the moistureproof mat, and make sure it’s firmly installed. Use the moistureproof mat can keep the floor dry.

2. Keep the Roborock S5 Robotic Vacuum Cleaner dock charger on a level surface, flat against a wall, plug into power outlet. Ensure to leave enough space to the dock charger.
Note: It will cause unexpected power outages and/or dock charger displacement if the power cable is dragged by main unit accidentally due to disorganized placed. The dock charger indicator is on after it’s plugged into power outlet, the indicator is off when main unit is being charged.

3. Turn on and charge the machine.
Press and hold the Roborock S5 Robotic Vacuum Cleaner button to turn on the main unit ,wait until the indicator light is on for a while ,then place the main unit on the dock charger to charge.
The machine is equipped with a built-in high performance lithium-ion rechargeable battery pack. To maintain battery performance, please keep the machine charged for normal use.
Note: The color of the circular light indicator refers to the quantity of electricity. White: power ≥20%. Red: power <20%.

4. Connect to the mobile phone client.
The Roborock S5 Robotic Vacuum Cleaner is compatible with Mi Home intelligent platform and could be controlled by Mi Home app. It supports the MIUI system and can be interconnected with other Mi Home intelligent products.
Please click here for detailed steps: Roborock S5 Robotic Vacuum Cleaner How to Quick Setup interconnected with other Mi Home intelligent products?

5. Roborock S5 Robotic Vacuum Cleaner Install the mopping module.
Step1: Install the mopping cloth: Wet the mopping cloth and wring it until it doesn’t drip. Insert it into the bottom along the slot of the water tank and stick it firmly.
Step2: Fill the water tank: Open the tank lid, fill it with water, and put back the tank lid.
Step3: Install the module: Push in the module along the bottom of the main unit and follow the alignment mark on the mopping module. A click sound means it is installed properly.
Note:In order to achieve a better mopping effect, it is recommended to use the main unit to clean the floor three times before install the mopping module.

6. Start cleaning.
When the circular indicator light on the main unit changes from slow blinking to stable, it means charging has completed. Briefly press button or start cleaning through the mobile phone client.

7. Remove the mopping module.
When the main unit is back on the dock charger after cleaning, press the buckles on both sides by hand, drag and remove the mopping module.
Note: Please use moistureproof mat if you put the dock charger on wood floor Remove tank when charging or not in use.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top
Need Help? Chat with us