The 70mai Smart Dash Cam Pro is equipped with professional video recording chip and image sensor for capturing high-quality videos.
Please install the product following the method below.
1. Install the electrostatic sticker
Take out the electrostatic sticker from the packing box and install it in the recommended area on the windshield, as shown in the figure below.
Please clean the windshield, and remove the air bubbles between the electrostatic sticker and the windshield during the installation.
2. Connect the 70Mai Dash Cam Pro to the bracket
Lock the bracket to the Dash Cam Pro, as shown in the figure below. You will hear a snap when it is in place.
3. Attach the Dash Cam Pro
Remove the protective sticker on the 70Mai Dash Cam Pro bracket and attach the Dash Cam Pro to the center of the electrostatic sticker, as shown in the figure below.
Press the bracket mount by hand to ensure that the heat resistant adhesive is in close contact with the electrostatic sticker.
4. Connect the power supply
As shown in the figure, run the power cable along the top of the windshield, down pillar A, and around the passenger-side
glove compartment. Arrange the end so that it runs to the cigarette lighter port. After connecting it to the car charger, plug the charger into the port.
5. Adjust the 70Mai Dash Cam Pro angle
Turn on the Dash Cam Pro and adjust the camera angle up and down against the preview screen to ensure that the camera is facing the front.